|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
So we connected out solenoid breakout and it is always sending power to all outputs. We tested it with a volt meter and it is even sending power when the robot is disabled. We are using 24v for the breakout.
Any help would be really appreciated! Thanks in advance! |
|
#2
|
||||||
|
||||||
|
Re: Solenoid Breakout Always Sending Power
Are the green LEDs lit on the NI 9472 module? Is the 9472 module in slot 3 of the cRIO?
|
|
#3
|
|||
|
|||
|
Re: Solenoid Breakout Always Sending Power
Well it is sending power regardless if the lights are on on the module. We tested it both ways. Yes it is in the 3rd slot.
|
|
#4
|
|||||
|
|||||
|
Re: Solenoid Breakout Always Sending Power
It shouldn't make a difference for your issue but have you wired the solenoid breakout to 24v and not 12v?
Pictures of your CRIO and PDB would help. |
|
#5
|
|||
|
|||
|
Re: Solenoid Breakout Always Sending Power
It is wired to the 24v connector, the same one as the one for the cRIO.
|
|
#6
|
|||
|
|||
|
Re: Solenoid Breakout Always Sending Power
Have you verified that the power input to the Solenoid Breakout is hooked up properly (i.e. not backwards)?
|
|
#7
|
|||
|
|||
|
Re: Solenoid Breakout Always Sending Power
Yes we have checked that. We connected it red-black-red-black in the same place as the cRIO power. And on the other side it follows the positive and negative on the Breakout bumper.
Last edited by slhs : 12-02-2014 at 09:07. |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|