|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Compressor troubleshooting
I'm having issues getting the compressor to turn on.
- I'm running the compressor example code to make sure it is not a coding issue. - The pressure switch is plugged in to DIO1 on the DSC. I've also switched out the pressure switch to make sure it is not the switch. - The spike is receiving its signal from Relay1 on the DSC. I've replaced the pwm cable with a brand new cable. - I've directly powered the compressor to make sure it runs. - The DSC is powered and all 3 lights are green. - The Relay1 light is green on the DSC (does this mean signal is being sent to the spike? I think so but can't remember as I type this). - The dashboard shows the switch is on and the compressor is running. - I changed the data cable from the cRIO to the DSC. - The light on the spike is on and amber, but never changes to green. I've replaced the spike to make sure it isn't the spike. What else can I try? I can't think of anything else in the loop to test. Thanks |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|