|
|
|
 I know our driver is going to nats over the prom. I mean come on, who wouldnt? :D - karinka13 [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| I know our driver is going to nats over the prom. I mean come on, who wouldnt? :D - karinka13 [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Break/Coast feature
Does anyone know how to program the jaguars to break using windriver I've searched up anything I could find about the break/Coast feature but I can't find out how to program it anywhere
Any help is appreciated, thank you |
|
#2
13-02-2014, 18:34
|
||||
|
||||
|
Re: Break/Coast feature
The brake/coast feature is on the speed controller. There should be small pins sticking out with a clip that plugs in the the brake or coast part of the controller. Refer to you speed controller's manual online to find where it is.
Last edited by Kevin Phan : 13-02-2014 at 18:46. Reason: Content |
|
#3
13-02-2014, 18:39
|
||||||
|
||||||
|
Re: Break/Coast feature
I normally prefer my speed controllers to brake, rather then break.
If you are using CAN on the jaguars, you can set brake/coast through the CANJaguar class. See CANJaguar::ConfigNeutralMode. Otherwise, like Kevin said, use the jumpers on the Jaguar. |
|
#4
13-02-2014, 22:09
|
|||
|
|||
|
Re: Break/Coast feature
On a Victor you can run a wire from the center of the three pins to a digital output. Switching the digital output will switch the Victor between brake and coast. I'm not sure if a Jaguar works the same way.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
