imaging tool does not see modules

[eddie12390]

Originally Posted by nheft

I tried re-imaging a cRIO-II with the 2014 imaging tool. The whole process runs through (takes about 30 minutes), gives me a message that the process completed successfully. After rebooting the cRIO and re-scanning I do not see any of the modules (I have one analog module, one digital module, and one pneumatics module installed).

I saw a similar problem last year. Went to another PC with the same version of the imaging tool - re-imaged the cRIO and saw the modules and all was well.

In all cases I am able to ping the cRIO from a command prompt with no problem.

Any ideas?

Thanks in advance

Neil Heft

Team 533 Advisor

Can you ensure that the cRIO is not working? As far as I know, the only time that the modules will show up is when using a 255.255.255.0 subnet mask but I could be wrong. I've seen weird bugs like that in the past but I've never had it cause any issues.