imaging tool does not see modules

[nheft]

- I'm able to ping the cRIO at 10.5.33.2 from a command prompt so I think the cabling is OK. (PC address is 10.5.33.5)

- The imaging tool formats the cRIO, reboots the cRIO, transfers a bunch of files to the cRIO over a period of about 30 minutes, and finally gives me a message that the re-imaging went successfully.

- When I deploy software, I get a message from the imaging tool that imaging process has completed successfully.

- When I re-scan, one PC sees the cRIO but not the modules. Another PC does not see the cRIO at all via the re-imaging tool but I can ping it from a command prompt.

- When I try to run the driver station I get "no robot communication"

- When I swap in another cRIO, I see the modules and the driver station sees the cRIO properly.