Toggle between in and out (Pneumatics)

Avoid the impulse to shoot from the hip, and find out the full picture before deciding where you stand. - gblake [more]

		Chief Delphi > Technical > Programming
Toggle between in and out (Pneumatics)

Thread Tools

Rate Thread

Display Modes

16-02-2003, 22:30

Coach C

Registered User

#0341 (Miss Daisy)

Join Date: Nov 2002

Location: Wissahickon High School

Posts: 13

Coach C is an unknown quantity at this point

You probably have something like this:

relayX_fwd = pX_sw_trig

You need something like this:

if (pX_sw_trig) then relayX_fwd = 1
if (pX_sw_top) then relayX_fwd = 0

If using two buttons is out of the question, you'll have to get a bit more creative:

if ((pX_sw_trig ~= LastState) & (pX_sw_trig = 1)) then
relayX_fwd = OpenClose
OpenClose = OpenClose - 1
endif
LastState = pX_sw_trig

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 22:05.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.