Connecting a Arduino to a cRio to control LEDs

More inspired students, more community involvement, less drain on the mentors... Sounds pretty swell to me! - Karthik [more]

		Chief Delphi > Technical > Programming
Connecting a Arduino to a cRio to control LEDs

Thread Tools

Rate Thread

Display Modes

18-02-2014, 11:15

Laxkief9098 Laxkief9098 is offline

Registered User

FRC #4557

Join Date: Jan 2014

Location: Connecticut

Posts: 17

Laxkief9098 is an unknown quantity at this point

Connecting a Arduino to a cRio to control LEDs

We are trying to use LEDs on our robot, so we purchased the LED kit on AndyMark which includes an Arduino controller (an ATMega328). we also downloaded the Aduino library for labview. In the LED examples there were a couple terminals in the initialize VI that I had a few questions about.
1) What is the VISA resource?
2) What is a XBEE connection and where is the serial port that I can connect the Arduino to the cRio?

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 21:55.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.