|
|
|
 Please understand that teams run things differently for specific and very valid reasons. And, this is OK as long as the students are inspired.
- Alexander McGee [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Please understand that teams run things differently for specific and very valid reasons. And, this is OK as long as the students are inspired.
- Alexander McGee [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
24-02-2014, 16:56
|
||||
|
||||
|
Re: Sheet Metal Parts
You should be able to change the bend position.
To get what you want, select the option so it places the bend outside of the face. Like this: http://www.chiefdelphi.com/forums/at...d=13932788 69 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode