Practical 3D printed parts

[gracie.]

We designed and 3D printed a part to mount encoders, too!
It made mounting magnetic encoders in several places on the robot a lot quicker and easier.

[nxtmonkeys]

If you look up my username on Thingiverse, you will find a 1/2 inch hex shaft-to-arm attacher that we used for a while.

Here's the link: http://www.thingiverse.com/thing:254208

[ToddF]

Originally Posted by Mr. Flaiz

Could someone post a picture of a 3d printed camera mount? Just looking for ideas.
Thanks

Here is ours. A simple angle bracket to hold the camera. Another part to hold light rings.

[Botwoon]

Originally Posted by wesleyac

Not very practical (yet!?), but 1678 tested out some 3D printed wheels this off season.
See here.

Sure they're practical. We've been using 3D printed wheels since 2010.

[Jon Stratis]

All of our 3D printed parts can be found on thingiverse in our 2014 collection: https://www.thingiverse.com/team2177/collections/2014

We have 4 distinct parts for this year:
Battery plugs
These have "Charged" and "Not Charged" on them, allowing you to have plugs in every battery while still indicating the state of the battery. Bonus points: Print the "Charged" in one color and the "Not Charged" in another!

Pneumatic storage tank holder
Designed to hold 4 tanks in a square pattern, can also be adapted to hold 2 stacked.

Ball Roller
We designed a roller for a 1/2" hex shaft. It has a curved surface to match the ball, and is 12" long (printed in 3 segments). Please note - you'll want to put something on it, like spray rubber, to aid in traction with the ball!

Winch spool
We're using a winch to pull our catapult down, utilizing 1" webbing. The spool prints in two parts, is designed for a 1/2" hex shaft, and has recessed 1/4" holes to secure everything together. It also comes with a guide that fits over the spool (with clearance holes for the 1/2" hex shaft) and helps ensure the webbing gets placed on the spool to avoid tangles. Obviously, it has a lot of compression force on the winch when it works, so we recommend using 100% infill!

[Brandon_L]

For a personal project

[coolhandluke811]

-Our "teeth" on our arms
-Encoder mounts
-The bushings on our clutch-winch
-Our control board: http://www.chiefdelphi.com/forums/sh...66#post1349166