|
Re: Battery Problem
Interesting, I show them as attending the Greater Toronto West Regional.
http://www.usfirst.org/whats-going-o...rogramCode=FRC
And as mentioned. Either you do not have power (12v, 20amp) running from the PD board to the Analog Breakout. Or the Analog breakout board is pre 2014 and need the jumper installed.. Or Both.
Good luck everyone!
Aloha
__________________
Team 3880 - "Tiki Techs" "Mr. H" - Tiki Technologies Coach / Mentor
Kealakehe High School Robotics - Kailua-Kona, Hawaii
__________________________________________________ _____________________________
2016 Hopper Division | Orlando Regional Engineering Inspiration Award | Hawaii Regional Chairman's Award & Finalist & Woodie Flowers Finalist
2015 Carson Division | Silicon Valley Regional Engineering Inspiration Award | HI Regional Regional Winners & Engineering Inspiration & Deans List Finalist
2014 Newton Division | Hawaii Regional Engineering Inspiration Award & Deans List Finalist
2013 Newton Division | Inland Empire Regional Regional Chairman's & Creativity Award | Los Angles Regional Engineering Inspiration Award | | HI Regional
2012 Curie Division | Hawaii Regional Engineering Inspiration Award
2011 Newton Division | Hawaii Regional Regional Winners & Industrial Design Award
.
__________________________________________________ _____________________________
Last edited by TikiTech : 26-02-2014 at 20:19.
|
I can't help but notice during the building sequence, there were a whole lot of student hands working on that robot.
Just sayin'. - Taylor [more] 
Hybrid Mode
