|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Pressure switch
How do you wire the pressure switch
|
|
#2
|
||||
|
||||
|
Re: Pressure switch
![]() |
|
#3
|
||||
|
||||
|
Re: Pressure switch
Take a PWM cable. Connect the black wire to one terminal, and the white wire to the other (you don't need the red wire). Plug the other end of the PWM cable into a DIO port on digital side car.
EDIT: Anthony beat me to it. |
|
#4
|
|||
|
|||
|
Re: Pressure switch
Use a PWM wire, remove the male end of the PWM and attach the black wire to one screw and the white wire to another screw, leaving the red wire unused. Then plug the female end of the PWM into the Digital Output 1 (DIO).
EDIT: Both of them beat me to it lol. Last edited by chigskonkwo : 04-03-2014 at 18:44. |
|
#5
|
|||
|
|||
|
Sweet. Thanks! What does the limit switch in the diagram do?
|
|
#6
|
||||
|
||||
|
Re: Pressure switch
It provides feedback for when a cylinder is activated. You don't need to have that.
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|