|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
ya the robot runs fine i think this is the problem
"If you are over working the motors and they get hot (remember the cims have no fan or anyway of circulating air) there is a possibility that the windings inside have shorted. The condition results in low power out, high current in and a burned smell when near the motor. Sorry, there is no coming back from this failure, replacement is the only answer." b/c there is a faint smell around them, and the motors are hot to the touch. Can we order replacement motors and bring them with us to the competietion, then switch em out on thursday? |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How much planning goes into your robot? | Jnadke | General Forum | 41 | 29-01-2006 21:29 |
| serious problem found - robot controller resets when jarred! | KenWittlief | Electrical | 23 | 19-03-2003 13:30 |
| WASH Palm scouting at the Championship | Mike Soukup | Scouting | 2 | 19-04-2002 15:14 |
| Index of team's post about their robot... | Ken Leung | Robot Showcase | 1 | 20-03-2002 17:10 |
| about how Drive Train push the robot... shouldn't the force accelerate the robot? | Ken Leung | Technical Discussion | 12 | 26-11-2001 09:39 |