|
|
|
 Add a little more grease if you aren't sure exactly how much you need. - MrForbes [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Add a little more grease if you aren't sure exactly how much you need. - MrForbes [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Connect Arduino to cRIO
How would I go about wiring my Arduino uno to the Digital Sidecar for use as a slave through I2C?
I tried just wiring up pins A4 & A5 to the SDA ans SDL lines but that did not work... I was reading somewhere that those two lines need pullup resistors, is this true and will this make a difference? Thanks, Chiller! |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode