INVENTOR EXPORTING - Chief Delphi

11-01-2002, 19:25

Ghetto_Child Ghetto_Child is offline

Registered User

#0253 (Mills Robotics Team)

Join Date: Jan 2002

Location: millbrae, CA

Posts: 51

Ghetto_Child is an unknown quantity at this point

INVENTOR EXPORTING

I am confused...

i need to export a drawing from inventor into a DWG format but when i did and when it was sent to a metal shop they said they want a format where they can rotate and dimension it themselves. inventor exports FUNKY.

HELP PLEASE HELP

confused: Help

Help

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Inventor -> 3D Studio	Adam Shapiro	Inventor	1	18-01-2003 12:35
Inventor 5/6 - I think I'm going to need a bigger boat!	roknjohn	Inventor	6	15-01-2003 14:22
Cybersonics Inventor Submisson 2002	Aaron Morris	Inventor	0	08-04-2002 16:36
Autodesk Inventor Award 2002	Digo	Inventor	1	24-03-2002 12:07
Inventor and Virtual Kit of Parts	Torchin	Inventor	1	09-01-2002 09:59

All times are GMT -5. The time now is 03:37.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.