SAT to DWG - Chief Delphi

11-01-2002, 20:06

Ghetto_Child Ghetto_Child is offline

Registered User

#0253 (Mills Robotics Team)

Join Date: Jan 2002

Location: millbrae, CA

Posts: 51

Ghetto_Child is an unknown quantity at this point

SAT to DWG

SAT to DWG

I am confused...

i need to export a drawing from inventor into a DWG format but when i did and when it was sent to a metal shop they said they want a format where they can rotate and dimension it themselves. inventor exports FUNKY.

[color=red][color=orangered]

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
SCRRF Meeting this Sat	Redhead Jokes	Southern California Regional Robotics Forum	0	12-06-2003 13:24
DWG file of Bosch Drill Motor?	Jacob Reif	Inventor	1	13-02-2003 21:58
QUESTION OF THE WEEK!!!	archiver	2001	28	23-06-2002 22:10
TEAM 121 and a rookie team on CBS SAT MORNING!	Joe Menassa	General Forum	7	21-03-2002 00:47
desperately need a vidcap of VCU awards (sat)	Andrew Dahl	Regional Competitions	1	15-03-2002 21:46

All times are GMT -5. The time now is 17:55.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.