|
|
|
 We're 3 pounds over. Drill until the hole saw is too hot to touch, then go find something else to cut off while you wait for it to cool down. - Richard Wallace [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| We're 3 pounds over. Drill until the hole saw is too hot to touch, then go find something else to cut off while you wait for it to cool down. - Richard Wallace [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
11-01-2002, 23:40
|
|||||
|
|||||
An update .....
Here's a little tip if these things jam on the shaft.
Don't try to punch the shaft through the coupling from the side with the set screw. This only makes it mad. Push or punch the shaft from the side without the set screw -or- Push on the coupling from the set screw side.[b] In other words ...... The shaft needs to move toward you when your looking at the side of the hub with the set screw. Confused yet ?  |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| read and write command | rosebud | Programming | 3 | 26-03-2003 19:44 |
| I'm gonna have to start hangin out with you guys/gals | archiver | 2001 | 4 | 23-06-2002 23:39 |
| What's gonna happen to the seniors??? | archiver | 1999 | 12 | 23-06-2002 22:52 |
| Are additional pulleys "cable fasteners"? | kmcclary | Off-Season Events | 6 | 26-10-2001 01:56 |
| 'read' posts that arent read | mike o'leary | CD Forum Support | 4 | 10-06-2001 11:29 |
Threaded Mode