|
|
|
 So yeah, everyone please remember that lathes are one of the most dangerous machine tools you'll encounter. And keep your hand on the chuck key whenever it's in the chuck. If you never let it go till it's out of the chuck, it's stupendously less likely to take flight. - Kevin Sevcik [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Dashboard Robot SDRead Communication Problems
We are having some difficulties reading variables from the smart dashboard. The SD Write vi's are working fine, and from the "Variables" tab of the dashboard we can verify that the variables' values are updating, but when we run the SD Read vi's in the robot code, we get either old or default values. This does not happen consistently, and when it does it only happens with some variables. Our robot can drive with no problems, and closing and reopening the dashboard fixes the issue. Any ideas?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode