|
|
|
 Successful teams - in almost any aspect of life (i.e. not just robotics) - don't make excuses and assign blame when something goes wrong. They improvise. They adapt. They overcome. They correct the problem and move on. - dlavery [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||||
|
||||||
|
Larry,
Nice job! Thanks for the picture of your set up. Promise me that you are going to support that 1/4 inch shaft when you mate it with a standard 32 DP gear and I will rest easier at nights ;-) Note to Rookies: Cantillever Shafts only when you know what you are doing. Simply supported (i.e. a support at each end) shafts are much preferred if you can manage it. Joe J. 
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Where to get CIM (Atwood, Chiaphua) motors? | DougHogg | Motors | 13 | 16-12-2003 13:21 |
| gearbox for atwood motors | DaveG702 | Motors | 3 | 17-12-2002 10:30 |
| Looking for practice motors & extra tape drive parts? | archiver | 2000 | 1 | 23-06-2002 22:54 |
| We can't find where to buy Chiaphua motors | stuy694 | Technical Discussion | 2 | 12-04-2002 17:19 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |
Hybrid Mode
