Pairing Drill Motors to Chiaphua

Once again, the GDC is pure evil. (Dave, Aidan, and Bill get the "pure evil genius" rating which is slightly worse.) - EricH [more]

		Chief Delphi > Technical > Motors
Pairing Drill Motors to Chiaphua

Thread Tools

Rating:

Display Modes

12-01-2002, 19:33

Matt_White Matt_White is offline

Registered User

#0451 (The CAT ATTACK)

Join Date: Jan 2002

Location: Sylvania, OH

Posts: 4

Matt_White is an unknown quantity at this point

Pairing Drill to Chiaphua

We are looking into pair the drill motor without it's designated gear box.

Does your 3.6 gear ratio take account for spur gear meshing loss. I did not factor it in for my 3.5 ratio.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
"Automatic Transmission"	Madison	Technical Discussion	70	24-11-2003 09:03
Complete Drill, Seat, and Window motors for trade	archiver	2000	0	23-06-2002 22:16
Complete Drill, Seat, and Window motors for trade	archiver	2000	0	23-06-2002 22:16
"Motors and Drive train edition" of Fresh From the Forum	Ken Leung	CD Forum Support	6	29-01-2002 12:32
what about the drill motors?	Ken Leung	Motors	2	26-06-2001 02:11

All times are GMT -5. The time now is 15:12.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.