VIAIR 250C-IG Compressor

[ArtemusMaximus]

Originally Posted by cbale2000

I used a multimeter with a temperature probe on it to get the reading. Don't know if its the most accurate but it seemed to work well for comparison at least. As far as where the probe was placed, I used the top of the heat sink since that's where the compressor seemed to get the hottest (and thus would show the greatest variation in the tests).



Unfortunately in my test the fan direction was dictated by the mounting solution required for it on the robot. That said, however, on this years robot we were using an identical compressor and a slightly smaller fan (80mm or 100mm, not sure) with the fan mounted above the compressor and the compressor was cool to the touch immediately after coming off the field, so top mounting seems to be effective as well (Though the compressor on our robot this year may also not have been working as hard).

I do agree though that it might be worth another test to see what, if any, difference direction makes to the mounting position of the fan.

Thanks again.
I wanted to add another thought. When I was looking to use bigger fan I realized that too big of a fan has a dead zone right under the center of the fan assembly. In my opinion it would be a good idea to place fan in such way that whatever needs to be cooled would be directly under the blades and not the center. I hope that make sense to everyone.