Vertical Mill for FRC - Chief Delphi

That's for us to know, and you to lose sleep over finding out! - Austin [more]

		Chief Delphi > Technical > Technical Discussion
Vertical Mill for FRC

Thread Tools

Rating:

Display Modes

22-05-2014, 02:47

Cory

Registered User

AKA: Cory McBride

FRC #0254 (The Cheesy Poofs)

Team Role: Engineer

Join Date: May 2002

Rookie Year: 2001

Location: Redwood City, CA

Posts: 6,795

Re: Vertical Mill for FRC

It's a giant (well actually small) POS...but if it's what you can fit, it's better than nothing, I suppose.

The Rong Fu RF-45 or the PM-45 (Basically the same thing. Might be some minor fit/finish differences. Probably made in the same factory) are ~3x more, but more than 3x more machine. You can actually do some real work on them and not hate life the entire time.

__________________
2001-2004: Team 100
2006-Present: Team 254

Last edited by Cory : 22-05-2014 at 02:54.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 20:04.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.