|
Re: Vertical Mill for FRC
Quote:
Originally Posted by theawesome1730
It depends on your budget of course, but look into a Bridgeport knee-mill. You can find some pretty decent ones for not tons of money nowadays. They are bigger, but can also handle larger loads if you need them to.
Edit: If power is a concern as you stated, a Bridgeport may not be within reason. Ours is 3-phase 208volt and I'm not sure if single phase 110 can be found
|
mine has the drive motor swapped to a off the shelf 110v
__________________
61 77 77 20 77 69 74 74 6c 65 20 62 61 62 79 20 63 6f 6e 64 6f 72 20 69 73 20 72 65 61 64 69 6e 67 20 43 44
|
When a vomit shooter runs out of balls, is it dry heaving? :p - Lil' Lavery [more] 
22-05-2014, 10:40
Threaded Mode