Quote:
Originally Posted by asid61
7075. The shaft was not bent, however, some of the shafts on the outer wheels on our WCD were 6061 and got bent. I still think there could be problems though. Looking at the forces involved here, the gear will want to move out of engagement.
Of course, just my opinion; the gear does look closer than the one on my gearbox did to the bearing.
Remember to put some kind of protection over the gears like polycarbonate, else wires will get stuck in there, as well as fingers.
It looks like there are two screws on the bottom of the gearbox that don't go all the way through the nut. Consider switching to thinner locknuts or lengthening the screw just in case.
|
I'm not understanding something here then; if it wasn't bent, how could the gear possibly come out of alignment? Were the tolerances bad? Were your bearings messed up? Were the bearings really close together?
...FIRST was created to change that world for the better. To presume that FIRST is simply here for your enjoyment is to demote it to nothing more than an expensive game... - RogerR [more] 
01-06-2014, 12:59
Threaded Mode