Bosch VS IPS Extrusion Systems

[Tony G.]

Hi Andy.

I see you've had a lot of experience using aluminum extrusion. The issue of 45x45 vs 30x30 is debatable. The message in my post comes from a lot of years designing modular structures exclusively with BOSCH aluminum extrusion. When in doubt, I tend to err on the side of caution & rigidity. But all of the other points you make very accurate and I am in total agreement with.
In the final analysis, there truly is little difference between most of the brands. Go with who will give you the best dea, free stuff,
design assistance (if you're new to this) and quick lead times.

The 2 brands I recommend are ITEM & BOSCH for product selection, quick delivery, quality and cost. Give the edge to BOSCH if local support is a factor. Every state has a local dealer who stocks and has a fab shop.

Wishing you and your team best of luck this year in what should prove to be an exciting competition. Best regards,

Tony G.
Team 569