|
|
|
 Ultrasonic sensors will allow you to do fundamentally the same thing that the bump sensors do...so you can slow down and smoothly stop your robot just before it reaches the end wall, instead of running into it at full speed and then figuring out "ohh! there is a wall there!" - dlavery [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: How do you use a servo motor with an Arduino using a bluetooth module?
|
|
#2
19-06-2014, 15:29
|
|||
|
|||
|
Re: How do you use a servo motor with an Arduino using a bluetooth module?
The HC-05 that is mentioned in the article posted by Steve works fairly well. I used a similar one over the summer for a project without any issues once I had it up and running (Arduino to a PC). Just don't wire it wrong. It is not very forgiving when you apply power where it doesn't belong. I originally saw a link to one here.
Mike |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
