Pneumatics system code

[Aren Siekmeier]

Originally Posted by Team 4939

The lights on the sidecar bumper are off but, the light on the spike is orange. My peers say they have never seen these lights go on before. The steps before step 3 are true.

They likely haven't seen them go on because you have never commanded a relay output before. The Relay output lights indicate the current output value.

Another thing to check: Are there any errors appearing on the diagnostics tab of the driver station? You can click Clear Errors to see if any new ones are being reported at the moment. Do this in Teleop Enabled as well. It might be that one of your safety loops is timing out, locking up your outputs. However, you report the other outputs working, so I'm not sure how this could be...

Do you have a multimeter on hand? It might also be worthwhile to unplug the cable from the spike and probe its ends, to see if the digital sidecar is sending an output despite its LED state.