|
|
|
 Instead of dreading the potential alliance think of ways to impress them so they want you to be part of it! - Koko Ed [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Instead of dreading the potential alliance think of ways to impress them so they want you to be part of it! - Koko Ed [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
05-07-2014, 17:31
|
||||
|
||||
|
Re: pic: 2-Speed Gearbox
You may need slightly larger fillets in the pockets to allow for a bigger endmill to work around. I would think a .125" radius would be nice for at least a 1/4" endmill, but more experienced machinist could chime in on a nice cutter size. The larger fillets will also reduce stress concentrations, strengthening the plates.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode