How to wire unrealistically well?

[RKazmer]

Originally Posted by evanperryg

A few more things:
-Get a hydraulic crimping tool and the terminals to go along with it. Not only do these look really good once they are heatshrinked, they are impossible to pull apart.

This is where you can find the hydraulic crimping tool we have used for the past two years. It works best with metal-only terminals, but it will do plastic covered terminals as well.
http://www.harborfreight.com/hydraul...ool-66150.html

One note about this tool: It does rust if left out, so make sure it gets put away as well as oil it every two to three weeks depending on the amount you use it.