Old 3 in. CIM - Chief Delphi

Hard work is a necessary prerequisite for luck. - Ian Curtis [more]

		Chief Delphi > Technical > Motors
Old 3 in. CIM

Thread Tools

Rate Thread

Display Modes

12-08-2014, 15:45

Crazy Ewok Crazy Ewok is offline

Registered User

AKA: Justin Bruck ( The Freshman!!)

FRC #3547 (Virus)

Join Date: Feb 2011

Rookie Year: 2011

Location: Dundee

Posts: 8

Crazy Ewok is an unknown quantity at this point

Re: Old 3 in. CIM

Thanks everyone for the info, very helpful. It's a small hobby lathe for wood turning only, I think the CIM will be ok. Thanks asid61, I have a 60 amp power supply ready for it.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 22:20.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.