|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
|
|||
|
|||
|
Re: Ideas for Ball Shifter?
You can swap to 11T pinions (P/N: 217-3107) on the CIM to get more of a reduction.
You can also direct drive a smaller wheel, such as a 3" Colson Performa. Even then, you're going pretty fast. If you're willing to machine gearbox plates, you have a bit more flexibility with ratios. VEXPro sells the shifting shaft separately. Last edited by Knufire : 20-08-2014 at 13:27. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|