Off season special project (Gearbox)

[magnets]

Originally Posted by Dragonslayerend

So this is our new gearbox about to be machined. It's for a special project we're doing. I wanted to ask if it looks okay and not suspicious about whether it will fail.
Specs:
-4 Cims
-9:1 GR
-Dual Output Shaft
-14lbs

Looks really good!
From just looking at it, I don't think it would fail. It's hard to get a good view of the plate design because they're dark black, but it seems like the center part with the three center bearings isn't too well connected to the outside parts. Check out picture of 254's gearbox plate design for some inspiration if you'd like.

[Dragonslayerend]

https://fbcdn-sphotos-h-a.akamaihd.n...61a7c5e8c4251c
Here's the plate view