pic: Roborio mounting and protective case

[Chadfrom308]

Originally Posted by faust1706

The case seems like it'd serve its purpose, to protect the roboRIO, I was just wondering how good of a job it really does. The worst case scenario the past few years would be either the 2014 game ball landing directly on it, or a Frisbee deflected into it. The latter has the potential to have a lot of force. FRC games are tough. You have to design durable parts.

I hope you don't mount your electronics where a big 2lbs ball or a supersonic (exaggerating here) frisbee could hit it!

I bet that it would protect it from most things, especially if you 3d print it properly. I don't think stress testing is necessary, and if this case goes through more than a little stress, shame on you