|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
|
|||
|
|||
|
I think I had a save error too sometime yesterday. But fortunately after 10 tries it worked.
Oh yes, I have a question about assembly files. Every time I open one, it prompts me to confirm every SINGLE associated ipt and it's sooo annoying. I don't understand why Autodesk would put a "skip all" command but not an "accept all" command. This problem only started happened when I organized different parts in different folder; I doubt autodesk intended to have everyone put all their ipt's in the root folder. absurd. JP AIM: JPRen2025 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Basic Run Error | BBFIRSTCHICK | Programming | 10 | 02-04-2003 22:43 |
| EMERGENCY! EPROM FULL error?!? | CHSguard72 | Programming | 2 | 05-03-2003 20:51 |
| How much can the window assembly lift? | archiver | 2000 | 9 | 23-06-2002 22:59 |
| Driving constraints in assembly | Jan Olligs | Inventor | 0 | 25-02-2002 07:11 |
| Basic Run Error | Ulibrium | Programming | 12 | 21-02-2002 01:02 |