|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#21
|
|||
|
|||
|
Re: pic: CV Robotics WCD 6wd Drivebase Prototype
If cutting fast and I don't care it gets up in the .030-.050 range. But if I take my time and get the settings right it is under .010. I'm not saying we don't do a little cleanup after cutting, but it is far more accurate than I am.
I have cut three plates for our mockup gearbox and on all three the gear mesh is very close to perfect. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|