pic: 2169 'not so summer' off-season project teaser

[llamadon]

Originally Posted by audietron

This looks really nice! I do have a couples questions.
1. Do you have more bearing blocks then needed for one complete drive?
2. Are the slimmer blocks for 3/8 axle?
3. What is the hole in the side of the blocks (tensioning?)

Just a couple things I've been curious about. Thanks

Thanks!
1. Nope, there are enough blocks for 4 axles, the bearing blocks are the ones with the bigger holes.
2. As previously mentioned those are actually for a 1/2 #20 bolt to be held for a tensioner.
3. It is a tapped hole for 1/4 #20 thread. This coupled with the bolt and bolt holder create linear motion with the bearing blocks, allowing for tensioning.