Fasteners: Black Oxide or Zinc Plated? - Chief Delphi

Go to Post

One of my management professors taught me this: At all times you are holding a bucket in each hand, one full of water, and one full of gasoline. Management is knowing when to throw which bucket. - Barry Bonzack [more]

Home

		Chief Delphi > Technical > Technical Discussion
Fasteners: Black Oxide or Zinc Plated?

Mark Forums Read

View Poll Results: What type of plating does your team use?
Black Oxide		50	62.50%
Zinc Plated		8	10.00%
No standard, whatever is fine		22	27.50%
Voters: 80. You may not vote on this poll

Thread Rating: 3 votes, 5.00 average.

Prev

Previous Post

Next Post

Next

#17

Spotlight this post!

Unread

03-12-2014, 15:58

pyroslev

pyroslev is offline

VirginiaFIRST FTA

AKA: Jack of all trades, Master of few

no team (Forget not 616)

Team Role: Alumni

Join Date: Nov 2004

Rookie Year: 2001

Location: Virginia

Posts: 414

pyroslev is on a distinguished road

Re: Fasteners: Black Oxide or Zinc Plated?

The only rust I've seen of any consequences are on robots improperly stored. So unless you're planning to store them in an outdoor location or unsealed space, you should be ok with whatever.

__________________

"Complications arose, ensued...were overcome." "I'd trade 500 CNC machines for one good hearted student."

From December to April, since 2002, I forfeit my mental sanity for perfect insanity.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 00:49.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.