pic: 3 CIM WCD Ball Shifter Dead Axle

[Bryce2471]

Originally Posted by Joey Milia

The PEM inserts are pressed into the opposite side of the plate from the bolt, they have a flange but the flush ones are pressed into the material flush which cold forms the material into groves in the nut. They can be sourced from mcmaster here http://www.mcmaster.com/#captive-nuts/=uy130o

GRT has used the standard ones in our GB for the past three years and the flush ones in the 2014 GB. You'll need a hydraulic press if the plates are anodized but if it's just raw aluminum an arbor press should do fine I think.

More info on flush ones here http://www.pemnet.com/fastening_products/pdf/fdata.pdf

and a lot more info on their website http://www.pemnet.com

Great. Thanks for the info. I'll be sure to look into it.