Where to start ... Here are a few tips for startes:
- Label your wires
- Keep power & motor cables short
- Use proper gauge wires for rated circuits (consult FRC manual)
- Label your wires
- Use proper wire strippers when removing insulation so as not to remove wire strands
- twist wire strands before inserting them into the PDB cage clamp terminals (prevents whiskers trom touching other circuits)
- Did I mention to label your wires?
- Route wires in a logical fashion and tie them down with zip ties
- Don't run power wires and PWM cables in one wire bundle
Nothing beats the local hardware store :). - Mike Martus [more] 
17-12-2014, 13:35
Threaded Mode