|
|
|
 I believe you have the right to develope your own opinion. I would suggest it be based on actual experience and facts. - Mike Copioli [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| I believe you have the right to develope your own opinion. I would suggest it be based on actual experience and facts. - Mike Copioli [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#1
|
|||
|
|||
|
Tips for Accurate Measuring and Machining
We do most of our machining by hand using only tape measures and calipers for measurements and sometimes have a difficult time properly marking and cutting or drilling accurately. I was wondering if anybody had any recommendations for tricks and best practices to get more accurate cuts (and hole placement in particular).
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode