|
|
|
 However, I do expect something truthful to come out of some of Dave's posts. - Karibou [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| However, I do expect something truthful to come out of some of Dave's posts. - Karibou [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#13
25-12-2014, 02:23
|
||||
|
||||
|
Re: Designing for Powder Coating
When I was dealing with powder coating, 1885, I would just drill the hole over again, the little powder coating that was in the hole would come right off.
You can also ask the person not to put any powder in the holes....that's probably the easiest thing. But if you take a bolt and thread it through then it would probably come off itself. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode