WCP SS used with Vex Drive in a Day Chassis

[zachrobo1]

Originally Posted by z_beeblebrox

Would it be a problem to simply rotate the gearbox a few degrees about the output shaft and avoid the interference entirely?

No, I perhaps should have put up a better screencap. The hole shown in the picture has to be bored on both sides of the large center hole because there are two screws to attach the gearbox.

[z_beeblebrox]

Originally Posted by zachrobo1

No, I perhaps should have put up a better screencap. The hole shown in the picture has to be bored on both sides of the large center hole because there are two screws to attach the gearbox.

If you rotated the gearbox, wouldn't one mounting hole would be slightly above the slot and the other slightly below it?