Go to Post Gotta love the use of universal technical terms, along with whatchamacallit, doodlespiel, whosiwhatsit... ;) - PaW [more]
Home
Go Back   Chief Delphi > ChiefDelphi.com Website > Extra Discussion
CD-Media   CD-Spy  
portal register members calendar search Today's Posts Mark Forums Read FAQ rules

 
 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
  #5   Spotlight this post!  
Unread 01-01-2015, 17:41
andytoennies andytoennies is offline
Registered User
FRC #3061 (Huskie Robotics)
Team Role: Alumni
 
Join Date: Jan 2013
Rookie Year: 2012
Location: Naperville
Posts: 7
andytoennies is an unknown quantity at this point
Re: pic: 3061 Huskie Robotics Pre-2015 WCD

Quote:
Originally Posted by Scott Kozutsky View Post
I'm pretty sure this isn't legal per 2014 rules (I don't know if it was supposed to be, besides "change is coming") given that the implied definition of "end" of a bumper is any corner.

4.6.8 R26
BUMPERS must be supported by the structure/frame of the ROBOT (see Figure 4-10). To be considered supported, a
minimum of ½ in. at each end of the BUMPER must be backed by the FRAME PERIMETER. Additionally, any gap
between the backing material and the frame
A. must not be greater than ¼ in. deep, or
B. not more than 8 in. wide.

This would mean that your side bumpers aren't properly supported. The definition may be grey enough to pass at some regionals but definitely not everywhere. Be careful.

http://www.usfirst.org/sites/default...ame_Manual.pdf

Aside from that, you don't need to use shaft collars for attaching encoders. Just drill a hole in any driven axle and shove the shaft of the encoder in there. (http://puu.sh/bSXmC/4694259cf2.jpg) Check the discussion here for more alternatives/experiences: http://www.chiefdelphi.com/media/photos/40864
You're totally right, I had forgotten that the side "corners" of the hexagon would be considered ends. I am working on a quick fix right now, will update when done.

As to the drive encoders, I did not realize that that configuration was possible. I'll try that as well. Thanks for the suggestions.
Reply With Quote
 


Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -5. The time now is 23:34.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright © Chief Delphi