Mecanum Wheel not spinning

[Jon Stratis]

Try swapping the leads with another wheel - basically, power the front wheel with the controller for the back one and vice versa. Hopefully, one of three things will happen. It works fine, telling you there was a loose wire somewhere, The original wheel stops spining again, telling you the issue is with the motor or some sort of mechanical issue, or the back wheel stops spinning, telling you the issue is with the speed controller, PWM, or PDP. It will at least help narrow down the possibilities!

Also, have you verified you aren't popping the breaker for that wheel?. A loose connection could cause increases current on that wheel only.

[Dominick Ferone]

We can test the breaker issue.
Also with us handling the bump, we have about an inch and a half of ground clearance and we were able to go over the bump fine. The thing is we have a wooden bump so you may need to calculate the difference in friction, and we were testing off a tile floor and not carpet.
The mecanum were also tested for pushing force. We weighed down our chassis to about 65ish pounds and loaded a single tote with 5 batteries and other materials and it was able o be pushed on the tile floor.