|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools |
Rating:
|
Display Modes |
|
#1
|
||||
|
||||
|
D-Link Router 2015 Config
Could someone put up the router config generated by the 2015 Bridge Configuration Utility? (We don't want to install & setup LabView just to uninstall it after we use the tool. Also, it's always nice to have a reference in case you need a quick manual fix.)
|
|
#3
|
||||
|
||||
|
Re: D-Link Router 2015 Config
Quote:
|
|
#4
|
||||
|
||||
|
Re: D-Link Router 2015 Config
I know that the roboRIO address is different but I wasn't sure about the router. Ignore my previous post. Download the tool.
|
|
#5
|
||||||
|
||||||
|
Re: D-Link Router 2015 Config
LabVIEW is not required for the radio config tool. It's installed by the 2015 FRC Update Suite, which also installs the driver station and roboRIO imaging tool? Do you also plan to uninstall those?
|
|
#6
|
|||||
|
|||||
|
Re: D-Link Router 2015 Config
The config is basically the same except you don't need an extra voltage regulator because with the new control system there's an included voltage regulating breakout.. Do basically same thing just slightly easier
|
|
#7
|
|||
|
|||
|
Re: D-Link Router 2015 Config
And you also need to configure the DHCP server on the router, but if you know a bit about networking that should be easy.
|
|
#8
|
||||
|
||||
|
Re: D-Link Router 2015 Config
I installed the 2015 FRC Update Suite, but it's not on here. Actually, neither is the Driver Station. Eclipse C++ compilation works though...
|
|
#9
|
|||||
|
|||||
|
Re: D-Link Router 2015 Config
Did you look in Program Files for the FRC Driver Station folder?
The 2015 Bridge Configuration Utility is located in Program Files/National Instruments/LabVIEW 2014/project/Bridge Configuration Utility Last edited by Mark McLeod : 10-01-2015 at 19:00. |
|
#10
|
||||
|
||||
|
Re: D-Link Router 2015 Config
The basics are:
1. Assign your team's IP address to the radio such as 10.TE.AM.1 2. Enable DHCP server to give out addresses like 10.TE.AM.* (maybe from .20 to .100) That should suffice for home (shop) use. PS: RoboRIO, the Driver Station and the developer's PC(s) are supposed to find each other via mDNS. |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|