|
|
|
 “There are two ways to compete, one is to drag your opponent down, the other is to raise the bar and excel. Which do you think is more beneficial to you in the long run?” -- John Abele - Candice.E [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Motor Control Help
I have programmed in Labview the last 2 years and have been successful. This year we cannot figure out how to use motor control with the new changes. We are also looking at using C++. We would really appreciate some guidance, resources, or example codes. Thank you.
|
|
#2
10-01-2015, 13:01
|
|||
|
|||
|
Re: Motor Control Help
http://wpilib.screenstepslive.com/s/4485 that is a great resource for help in programming, they have a few examples for each component
|
|
#4
10-01-2015, 13:56
|
||||
|
||||
|
Re: Motor Control Help
You probably found them already, but there are porting guides available...
http://wpilib.screenstepslive.com/s/...e-2014-to-2015 http://wpilib.screenstepslive.com/s/...e-2014-to-2015 |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
