|
|
|
 I come to Chief Delphi to get away from the mundane, everyday news. It's part of what makes the forum appealing to me. If I want to read world news, I'll go to digg. - Ryan Dognaux [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: LIDAR Sensor with a motor in it
Based on the Q & A response I would remove the motor (or the whole base) and you are good. It is too bad they didn't whitelist the Kinect since it was a KOP device.
|
|
#2
12-01-2015, 17:10
|
||||
|
||||
|
Re: LIDAR Sensor with a motor in it
So based on the Q&A you will not find out until inspection. If what is in the Kinect is a "motor" not listed in the rules, you will have to replace it one listed in the rules (window motor
 )& control it from the RoboRIO. You are better off calling it a "servo". Hopefully the GDC rethinks this & interprets a fully enclosed COTS sensor motor to be equivalent to a hard drive or fan. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
