|
|
|
 HEY! a robot that occupies 4 dimensional space is against the rules! - KenWittlief [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| HEY! a robot that occupies 4 dimensional space is against the rules! - KenWittlief [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
No lights on PDP
On our current setup we see no LEDs on our PDP when we apply power to it. We get power going to each of our components but the two status lights at the bottom don't light up at all. We checked the can network and saw that the PCM is being sensed but not the PDP. We have wired it correctly and have no idea what it means when no lights are on, and yes we did look up the light signals for the board. I'm greatly confused by this and any help the be awesome!
|
|
#2
14-01-2015, 19:00
|
|||
|
|||
|
Re: No lights on PDP
http://www.chiefdelphi.com/forums/sh...&highlight=pdp
We have this issue as well, have been in comms with Cross the Road to get it swapped out. Hopefully they are able to isolate the issue. You should contact them as well.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
