|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
|
||||
|
||||
|
Re: pic: Crevolution 2015 Drive Module
Looks pretty good, although personally I just like using 1/4" or 3/16" thick for gearboxes and such (more thickness for press fits and counterbores).
Are you planning on tensioning the belt, or are you just going C-C? If you did a slight redesign, you could tension the belt like 192 did for their 2014 gearbox (look it up, pictures on CD). |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|