[Ri3D] ‘Snow Problem presents Prometheus

Last year we saved a ton of money by using a good bit of square tubing for the frame of our robot, square tubing is a lot cheaper then C channel. We get to use so much raw material that the cost should go down in certain places. - Derrick Maust [more]

		Chief Delphi > FIRST > General Forum
[Ri3D] ‘Snow Problem presents Prometheus

Thread Tools

Rate Thread

Display Modes

14-01-2015, 23:37

peirvine

GOFIRST Director of Engineering

AKA: Peter Irvine

FRC #2175 (Fighting Calculators and Ri3D 'Snow Problem)

Team Role: Mentor

Join Date: Mar 2012

Rookie Year: 2011

Location: Woodbury

Posts: 82

peirvine is an unknown quantity at this point

Re: [Ri3D] ‘Snow Problem presents Prometheus

Quote:

Originally Posted by Joey1939

I noticed blue tape over the extra ports on the roboRIO and PDP. Did you find this necessary for a certain reason?

We got a piece of Aluminum in it that shorted a PMW on the Athena (roboRIO) which caused the whole system not to run. Once we found that out we removed it and decided to tape over all the exposed pins to prevent that from happening. We taped over the PDP because metal shavings in there would be bad...

__________________

2014 Northern Lights Regional-Winners (Thanks 359 and 2502)-Industrial Safety Award-Excellence in Engineering-North Star Regional-Industrial Safety-Creativity-WFFA (my dad!)-Semifinalists (Thanks 967 and 4607 (again!))

- Division Finalists (Thanks 2169 and 3284)
2013 Northern Lights Regional - Quarterfinalists, Entrepreneurship Award - Dean's List Semi-Finalist - North Star Regional - Winners (Thanks 967 and 4607), Team Spirit Award - 2013 MSHSL State Tournament - Winners (Thanks 2052 and 4607) - IRI
2012 Lake Superior Regional - Quarterfinalists, Coopertition Award - North Star Regional - Quarterfinalists, Creativity Award

-North Star Regional - WFFA Will Preska, Semifinalists

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 00:01.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.