Connect to Shaft of RS 775 Motor

[amesmich]

Thanks for all the feedback. It does not fall on deaf ears. The speed is a good point. We are considering a gearbox but needed to plan for any possibility.

Thanks

[FrankJ]

I use the green bearing retainer Loctite with a tite slip fit. Getting the press fit just right & bending the motor shaft is right next to each other.

When you say voltage drop do you mean your adjusting the 18 volt curves for the 12 V available?

[amesmich]

Originally Posted by FrankJ

I use the green bearing retainer Loctite with a tite slip fit. Getting the press fit just right & bending the motor shaft is right next to each other.

When you say voltage drop do you mean your adjusting the 18 volt curves for the 12 V available?

We readjusted for the 12v and then accounted for a non-ideal power source. So voltage drop of battery under load or after some time. Not a big factor for us but not forgotten either.